Well, I reached the section in the manual where it is time to wind the toroid chokes. First the toroid cores were separated into their groups.
 |
| Toroid cores |
 |
| tinning the leads to the Toroid choke |
 |
| RFC14 installation |
 |
| Size of the RF Choke |
 |
| RFC16 |
Saturday, December 10, 2011
Elecraft K2 - Serial Number 007239 Build. Day 21
Hours 1:00:00 Total Build Time: 41:15:00 Dec 10, 2011
Well, I reached the section in the manual where it is time to wind the toroid chokes. First the toroid cores were separated into their groups.
The first RF Choke wound was RFC14. It is shown installed in the photo below. The manual had good instructions telling how to wind the choke.
Here is another shot of RFC 16 which was also installed today.
Well, I reached the section in the manual where it is time to wind the toroid chokes. First the toroid cores were separated into their groups.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment