Hours 2:43:00 Total Build Time: 28:37:00 Nov 12, 2011
Work continued on the RF board. All of the time was spent stuffing and soldering 1/4 watt resistors.
 |
| Soldering 1/4 watt resistors on the RF board |
The lighted magnifying glass really helps when soldering the components onto the board.
 |
| Checking off components as they are installed on the RF board |
I found the 'Annotate' mode in "Preview" when viewing a .pdf file. I downloaded the K2 manual and errata sheet, made notes in the manual where there were changes from the errata sheet. I check off each step in the manual after installing the part. I like having the ability to also highlight, and add book marks.
 |
| Installing resistors on the RF board |
Dang those parts are small. The resistors in this case are not to hard to see. There are some capacitors where the writing is so small that I even have a hard time identifying the part using the magnifying glass.
 |
| Installing resistors on the RF board |
 |
| Resistor packs added to the RF board |
No comments:
Post a Comment